Youngstown Pump Pros logo Youngstown Pump Pros

2026-11-10 · Mike Santini

Sump Pump Not Turning On? Check These Four Things First

A sump pump that will not start is sometimes a failed pump and sometimes a tripped outlet, and those are very different afternoons. The checks below take a few minutes, need no tools, and resolve a real share of the calls that come in as a dead pump. Work through them in order before you call anybody — including us.

Before anything else: if there is standing water on the basement floor, do not walk into it to reach the pump. Shut off power to the basement circuits at the breaker panel first. Water and an energized pump cord are the one part of this job that is genuinely dangerous.

1. The GFCI outlet

Sump pumps are normally plugged into a GFCI-protected outlet, and a tripped GFCI leaves the pump completely dead with no other symptoms. Look for the small reset button on the outlet face — or on another outlet upstream on the same circuit, which is where people miss it — and press it firmly. If the pump comes back to life, note that GFCIs do not usually trip for no reason: a pump that trips it repeatedly has a developing ground fault in the motor or cord and needs looking at before the next storm, not after.

2. The breaker

If the GFCI reset does nothing, check the panel. A sump pump on a shared circuit can be knocked out by something else entirely on that circuit. Reset the breaker once. If it trips again immediately, stop — something is drawing a fault, and that is a call rather than a second reset.

3. Lift the float by hand

This is the single most useful test in sump pump diagnosis. With power confirmed at the outlet, take the pit lid off, reach down and lift the float. If the pump kicks on, your pump and motor are fine and the problem is the float: it was stuck against the pit wall, hung on the discharge pipe or power cord, or fouled with silt and gravel. Free it, clear the pit, and make sure it has room to swing through its full travel. If the pump stays completely silent with good power and a freely moving float, the switch or the motor has failed and it needs parts.

4. Look at what is in the pit

Open the lid and look at the bottom. Silt, gravel and debris accumulate invisibly over years, and they cause two separate failures: they give the float something to jam against, and they get pulled into the intake screen and impeller. A pit with several inches of sediment in it is a pump that has been working against its own environment. A shop vac clears it in ten minutes and is worth doing annually whether or not the pump is currently misbehaving.

What the symptoms mean if the checks do not fix it

Once power is confirmed and the float moves freely, the symptom narrows things down. Completely silent points to a failed switch or an open motor winding. Humming without moving water points to a jammed impeller or a seized bearing — and should not be left running, because that current draw will cook the motor. Tripping the breaker on startup points to a locked rotor or a failing winding. Running but barely clearing water points to a clogged intake, a failed check valve or a blocked discharge line rather than the motor itself.

Worth knowing before you decide to repair: on a pump past about eight years, a motor or impeller failure is usually the point to replace rather than rebuild, because the rest of the unit is at the end of its service life too. A failed float switch on an otherwise healthy pump is a straightforward repair at almost any age. If you have worked through these checks and the pump is still dead, call (330) 448-5984 during business hours — tell us which symptom you landed on and we will bring the right parts.

Sump Pump Failing in Youngstown, OH? Call (330) 448-5984

Talk to a local sump pump repair company serving Youngstown, Boardman, Austintown, Warren, Canfield, Poland and the rest of Mahoning County.

Call now Get a quote